Connect the Commander CORE USB cable to an available USB 2.0 header on your motherboard.NOTE: The Commander CORE can support up to 6 CORSAIR PWN RGB fans.Connect the PWM and LED cables of your fans to the Commander CORE.Connect the Elite Capellix’s 24-pin cable to the appropriate port on your Commander CORE.Mount your Commander CORE using the double-sided tape.Find a suitable place on your system where the iCUE Commander CORE can be mounted.Once your cooler is installed to your motherboard, it is time to connect the fans and pump to the iCUE Commander CORE. Step 3: Connect the fans and pump to the iCUE Commander CORE You should also rout the cables from the pump head to the back of your system.Connect the pump tach cable to the CPU_FAN header of your motherboard.Doing so will damage the retention hooks. Tighten the thumbscrews until the cooler is secure.Align the bracket with the stock AMD mounting clips and install the cooler by slipping the screw clip loops over the retention hooks.Once you have swapped out brackets, you can install your cooler into your PC system. You need to have enough slack to get the screw clips over the retention hooks of the mounting clip. Do NOT tighten the thumbscrews all the way.Install the AMD screw clips into the bracket and loosely secure them with the thumbscrews.Make sure the bracket is evenly secured on all sides before installing your cooler.Install the AMD bracket by pushing both sides into the slot on the pump.Remove the pre-installed Intel bracket from the pump head.You will need to swap the bracket out for an AMD bracket to properly mount your cooler pump.

The Elite Capellix comes with an Intel mounting bracket pre-installed. Step 1: Swap out the pre-installed bracket You can also find a PDF of the instruction manual here. These instructions are applicable to AMD sockets.

Need help installing your iCUE Elite Capellix liquid CPU cooler? We have video and written instructions to help you out.

Aorus rgb fan commander install